Table of Contents
Advertisement
Setup Mode
The RIBBON Page
The RIBBON Page
The RIBBON page lets you define the controller assignment for the PC3K's ribbon controller.
The optional Ribbon controller senses movement when you press on it and move your finger left
or right; this creates numerous possibilities for controlling pitch, volume, panning, crossfades
between zones, or any other uses you might imagine.
The optional Ribbon controller can be used as a single long controller, or it can be divided into
three separate sections, each with its own controller assignments (this is done on the RIBCFG
page, see below). The two small arrows above the strip indicate the boundaries of the three
sections. The large arrow above the ribbon points to the center of the ribbon, for when the ribbon
is configured in one section.
Note that there are three assignable parameter groups on the RIBBON page. When the Ribbon is
set to act as a single section controller, the only parameters that affect its behavior are those of
Section 1 (Sect1). When the Ribbon is set to act as a three‐section controller, each parameter
group affects only its respective Ribbon section.
To modify other ribbon parameters, go to the The Ribbon Configuration (RIBCFG) Page below.
The RIBBON page parameters are described in Continuous Controller Parameters on page 7‐30.
Parameter
Destination
Scale
Add
Curve
Entry Value
Exit Value
7-40
Range of Values
Control Destination List
± 300%
-128 to +127
Linear, Compress, Expand
None, 0 to 127
None, 0 to 127
Default
MIDI21
100%
0
Linear
None
None
Advertisement
Table of Contents
