Table of Contents
Advertisement
Program Mode
The Drawbars (DRAWBR) Page
The Drawbars (DRAWBR) Page
Press the Drawbr soft button to view the DRAWBR Page. This page lets you edit KB3's
drawbars.
Mode
When you set Mode to Preset, the preset drawbar settings on this page will be installed at
program selection. The drawbar values will immediately change, however, as soon as you move
the corresponding drawbar. Set Mode to Live if you want the drawbar volume settings at
program selection to be determined by the positions of the drawbar controllers (sliders). With
either setting, any engagements of the drawbar controllers subsequent to program selection will
affect drawbar volumes.
Steps
This parameter lets you specify the increments by which drawbar volumes will change. Choose
either 0–8, to approximate the drawbar settings on actual organs, or choose 0–127 for a finer
degree of resolution.
Volume
This parameter appears only if you've set Mode (see above) to Preset. Use the Volume
parameter to set the preset volume of each of the nine drawbars. The available values will be
0–8 or 0–127, depending on the setting of the Steps parameter.
Tune
This parameter lets you tune each of the nine drawbars up or down in semitone steps. The
values for the Tune parameter on the DRAWBR page shown above represent standard drawbar
settings on a real B3, as shown in Table 6‐1 on page 6‐5.
The Set Drawbars (SetDBR) Soft Button
Press the SetDBR soft button to capture the current position of the drawbars, and use those
positions as the preset drawbar positions on the DRAWBR page.
6-62
Advertisement
Table of Contents
