Table of Contents
Advertisement
TRIGGER KEYS (KEYTRG)
The TRIGGER KEYS page (see below) allows you to set a controller destination to be triggered
by playing a specific key.
In addition to generating a standard MIDI note on message, each key of the PC3K can be set to
trigger a controller destination. TRIGGER KEYS can be set independently per Zone. By using
Zones with overlapping key ranges, a single key can trigger multiple controller destinations. On
the TRIGGER KEYS page, select the Key field and choose a note by holding the Enter button
and playing the desired key (you can also use the Alpha Wheel, ‐/+ buttons or alphanumeric pad
to choose a note.) With the desired note selected, use the Dest field to select a controller
destination (see The Controller Destination List for details.) Set a value to send to the controller
destination with the Value field. Once a destination and value are set, the playing the key will
send the value to the controller destination on the Zone's MIDI Channel (see Channel on page 7‐7
for details on setting each Zone's MIDI channel.) This may also send a continuous controller
message to the MIDI or USB out ports, depending on the Zone's Destination parameter (see
Destination on page 7‐7 for details.)
Recording A Setup To Song Mode
The MIDI output of a setup can be recorded to a song in Song mode. Each MIDI channel that is
output from a setup is recorded into each track of a song (if the tracks have corresponding MIDI
channels.) Programs from each zone of your setup are automatically assigned to tracks in Song
mode. Follow these steps for proper recording of a new song from a setup:
1.
2.
3.
4.
5.
6.
7.
Enter Song mode by pressing the Song Mode button.
On the Song mode MAIN page, select 0*New Song* in the CurSng field by entering 0 on
the alphanumeric pad and pressing the Enter button. This loads a default empty song file.
On the Song mode MAIN page, select Mult in the RecTrk field.
Press the Setup Mode button to enter Setup Mode and choose the desired setup.
Press the left and right cursor buttons simultaneously to reach the TEMPO Page. Enter a
tempo by tapping the Tap soft button or enter a tempo in the Tempo field. When you are
finished, press the Done soft button to return to the Setup mode main page.
Press the Record button and then the Play/Pause button to begin recording. The
metronome will count off 1 bar and then recording will begin (you can set metronome and
other recording settings in Song mode.)
Press the Stop button to stop recording. You will see the usual Song mode save changes
dialog where you can review, retry, or save your song (see The Save Changes
Dialog on page 12‐8.)
Setup Mode
TRIGGER KEYS (KEYTRG)
7-69
Advertisement
Table of Contents
