Mercedes-Benz COMAND Operating Instructions Manual page 116

Additional settings
114
database that is to be installed are
displayed.
Select Yes Yes or No No
X
After selecting Yes, an activation code Yes
must be entered when installing a database
for the first time. You will receive the
activation code when you buy the
navigation DVD.
If you select No No, the process will be
canceled.
Enter the activation code.
X
After entering the activation code
correctly, COMAND starts updating the
digital map. Once the update is finished,
you will see a message.
To confirm the message: press W the
X
COMAND controller.
Take the DVD out of the slot.
X
While the update is running, you will see a
message to this effect and a progress bar.
The navigation system is not operational
until the update is complete.
i
You cannot eject the DVD during the
update. If you switch off COMAND during
the update, the update is interrupted. It
then continues from where it was
interrupted when the system is restarted.
COMAND may prompt you to change the DVD
during the update.
Press the V (for DVD changer) or
X
8 (for single DVD drive) load/eject
button.
Take the DVD out of the slot.
X
Insert the requested DVD.
X
Once the update has been successfully
completed, you will see a message to this
effect.
To confirm the message: press W the
X
COMAND controller.
Take the DVD out of the slot.
X
The update is complete.
If the update is not successfully completed,
you will see a message that the map update
is not possible.
and press W to confirm.
To confirm the message: press W the
X
COMAND controller.
Take the DVD out of the slot.
X