Flueing - Regency PG36NG5-R Owner's Installation Manual

These fl ueing systems, in combination with the PG36 Room Sealed Gas Fireplace, have been tested and listed as a Direct Vent type fl ue system
by the Australian Gas Association. The location of the termination cap must conform to the requirements in the Flue Terminal Locations diagram in
the "Exterior Flue Termination Locations" section.
Regency ® Direct Vent (Flex) System Termination Kit (Part # 946-515) includes all the parts needed to install the PG36 with a maximum
run of 1200mm.
1) 175mm dia. fl exible liner (1200mm length)
2) 100mm dia. fl exible liner (1200mm length)
3) spring spacers (4)
4) thimble (2)
5) AstroCap termination cap (1)
6) screws (12)
7) tube of Mill Pac (1)
8) plated screws (8)
9) screws #8 x 1-1/2" Drill Point, Stainless
Steel (4)
If longer runs are needed, the Regency
Direct Vent system (Flex) # 946-516 includes
all the parts needed to install the PG36 with
a maximum 3.0m run.
1) 175mm dia. fl exible liner (3.0m length)
2) 100mm dia. fl exible liner (3.0m length)
3) spring spacers (7)
4) thimble (2)
5) AstroCap termination cap (1)
6) screws (12)
7) tube of Mill Pac (1)
8) plated screws (8)
9) screws #8 x 1-1/2" Drill Point, Stainless
Steel (4)
Notes:
1) Liner sections should be continuous without any joints or seams.
2) Only Flex pipe purchased from Regency
3) If you are installing the PG36 into a Regency
to include the mantel base in your calculations and to maintain the 32mm clearance (38mm with Flex) to the underside of the mantel
top.
®
Regency PG36-5 Gas Log Fireplace

FLUEING

®
Regency Direct Vent System (Flex)
Horizontal Terminations Only
4" (102mm)
dia. flue pipe
®
6-7/8"
(173mm)
dia. Flue pipe
®
may be used for Flex installations.
®
Mantel Kit, use the minimum horizontal vent height (centre-line of 1029mm). Remember
INSTALLATION
Wall Thimble
spring spacer
AstroCap
Termination Cap
(Part# 946-578/P)
(patented)
11