Table of Contents
Advertisement
INSTALLATION
29) Install the wire cover by fi tting the 3 clips onto the fl ange at the front
of the fi rebox. See note below for PG36 units.
Wire Cover
Firebox Flange
NOTE - PG36 UNITS ONLY:
For the wire cover to fi t in place on the PG36 the top half of the
wire cover will need to be broken off by bending back and forth.
28
One clip shown in place
on fi rebox fl ange.
Bend Here
30) Plug in power source.
31) Turn the unit ON using remote control.
32) Press and hold the reset switch for 3 seconds and then release.
33) Close the bottom louver.
NOTE:
The fan must run at minimum speed to prevent the unit from overheating
which will cause automatic shutdown via the thermodisc safety switch.
If the thermodisc safety switch shuts the unit down, the unit will need to
be reset before restarting the unit after it has cooled down. To reset the
unit press and hold the reset switch for 3 seconds and release.
®
Regency
PG36-5 Gas Log Fireplace
Advertisement
Table of Contents
