Regency PG36NG5-R Owner's Installation Manual page 27

20) Install the supplied hinge to the thermodisc bracket using 2
screws.
21) Slide the thermodisc bracket in to the left side of the unit and align
the bracket holes with the screw holes on the fi rebox fl ange.
22) Connect new wire harness to the module and to the valve.
Module
®
Regency PG36-5 Gas Log Fireplace
Thermodisc
Bracket
Valve
23) Put the module back in place on velcro at the base of the fi rebox.
24) Secure loose wires using wire clips to the base of the fi rebox as far
back as possible.
25) Reconnect reset switch wires.
26) Re-install heat shield.
27) Mount control switch to the bracket on the bottom louver and secure
using 3 screws.
28) Align the bottom louver mounting tab with hinges on the left and right
side and secure using 2 screws on each side.
INSTALLATION
27