Premium Flush Front Installation - Regency PG36NG5-R Owner's Installation Manual

1) Unplug the power source.
2) Remove the top louver (if fi tted) by carefully pulling it out.
3) Install the premium fl ush front top louver in place by sliding the louver
tabs into the louver brackets on the inside top of the fi rebox.
Louver Tab
Premium Flush Front Top Louver in place.
4) Open the bottom louver.
5) Remove the manual control switch bracket from the bottom louver
(if fi tted) by undoing the 2 screws.
Manual Control
Switch Bracket
®
Regency PG36-5 Gas Log Fireplace

PREMIUM FLUSH FRONT INSTALLATION

6) Remove the bottom louver (if fi tted) by undoing the 2 screws which
secure the louver to the hinges on the left and right side.
7) Remove the heat shield by undoing the 2 screws.
8) Carefully disconnect the reset switch wires.
9) Lift the module off of the velcro from the base of the fi rebox and pull
out slightly.
10) Disconnect the wire harness on the module that is connected to the
valve.
INSTALLATION
25