Table of Contents
Advertisement
INSTALLATION
OPTIONAL
BRICK PANELS
1) Undo the bottom 2 door latches and open
and remove glass door. Remove logs.
Note: The logs must not be in the unit.
2) Insert the back brick panel fi rst by carefully
slipping it between the back wall of the
fi rebox and the rear log bracket.
3) Put the side panels in next. Slide them in
from the front and push them fl at up against
the wall. Be very careful not to scratch them
on the fi rebox hardware.
4) Install the 2 brick retaining clips, one on
each side.
22
LOG SET
INSTALLATION
Read the instructions below carefully and
refer to the diagrams. If logs are broken
do not use the unit until they are replaced.
Broken logs can
interfere with the pilot
operation.
The gas log kit (Part # 512-930) contains the
following pieces:
a) 02-49
Rear Log
b) 02-55
Middle Left Log
c) 02-50
Front Left Log
d) 02-53
Center Left Log
e) 02-51
Front Bottom Log
f)
02-54
Center Right Log
g) 02-52
Middle Right Log
h)
Embers
i)
Vermiculite
The "02" refer numbers (i.e. 02-49) are
molded into the rear of each log.
NOTE: If you will be installing the optional
Brick Panels, install the Brick Panels
prior to installing the logs.
1) Carefully remove the logs from the box and
unwrap them. The logs are fragile, handle
with care - do not force into position.
2) Sprinkle the vermiculite around the fi rebox
base.
Vermiculite
Vermiculite
3) Place the Log 02-49 on the rear log support
pins with the fl at side to the back.
4) Place Log 02-51 on the front right side of
the burner. Push the back of the log against
the 2 brackets with the notch on the bottom
right side of the log fi tting into the right side
of the grate.
Bracket
02-49
5) Position Log 02-53 across the cutouts in
Logs 02-49 and 02-51 with the notch on the
left side of the log fi tting into the 2nd grate
tab.
Vermiculite
2nd Grate Tab
®
Regency
02-49
02-51
Bracket
02-51
02-53
02-49
02-51
Cutouts
PG36-5 Gas Log Fireplace
Advertisement
Table of Contents
