C41 Check Circuit 764 (Br/W) For Short To Power; C42 Check The Pid Plate_D For Open; C43 Check Circuit 763 (O/W) To The Contact Plate Switch D - Ford Expedition 1998 Workshop Manual

1998 Expedition/Navigator Workshop Manual

C41 CHECK CIRCUIT 764 (BR/W) FOR SHORT TO POWER

C42 CHECK THE PID PLATE_D FOR OPEN

C43 CHECK CIRCUIT 763 (O/W) TO THE CONTACT PLATE SWITCH D

http://www.fordtechservice.dealerconnection.com/pubs/content/~WSWJ/~MUS~LEN/21/...
Is the resistance less than 5 ohms?
Yes
GO to C41.
No
REPAIR circuit 764 (BR/W). CLEAR the DTCs. TEST the system for normal operation.
Measure the voltage between transfer case assembly C201-9, circuit 764 (BR/W), and ground.
Is any voltage indicated?
Yes
REPAIR circuit 764 (BR/W). CLEAR the DTCs. CYCLE the ignition to OFF, then ON. TEST the system for normal
operation.
No
REPLACE the GEM; REFER to Section 419-10. CLEAR the DTCs. TEST the system for normal operation.
NOTE: The active command PLATE PWR is located in the 4-Wheel Electric Shift active command menu.
Set the active command PLATE PWR to ON.
Monitor the PID PLATE_D.
Does the PID PLATE_D not indicate OPEN?
Yes
GO to C44.
No
GO to C43.
Connect a jumper wire between transfer case assembly C201-10, circuit 762 (Y/W), and C201-13, circuit 763
(O/W).
Monitor the PID PLATE_D.
Does the PID PLATE_D indicate closed?
Yes
GO to C47.
No
GO to C45.
Page 52 of 64
8/30/2010