1998 Expedition/Navigator Workshop Manual
B48 CHECK CIRCUIT 764 (BR/W) TO THE CONTACT PLATE SWITCH C
B49 CHECK CIRCUIT 764 (BR/W) FOR SHORT TO GROUND
GEM C241
B50 CHECK CIRCUIT 764 (BR/W) FOR OPEN
http://www.fordtechservice.dealerconnection.com/pubs/content/~WSWJ/~MUS~LEN/21/...
Does the PID PLATE_C not indicate OPEN?
Yes
GO to B49.
No
GO to B48.
Connect a jumper wire between transfer case assembly C201-10, circuit 762 (Y/W), and C201-9, circuit 764
(BR/W).
Monitor the PID PLATE_C.
Does the PID PLATE_C indicate CLOSED?
Yes
GO to B52.
No
GO to B50.
Measure the resistance between transfer case assembly C201-9, circuit 764 (BR/W), and ground.
Is the resistance greater than 10,000 ohms?
Yes
REPLACE the GEM; REFER to
Section
419-10. CLEAR the DTCs. TEST the system for normal operation.
No
REPAIR circuit 764 (BR/W). CLEAR the DTCs. CYCLE the ignition switch to OFF, then ON. TEST the system for
normal operation.
Measure the resistance between transfer case assembly C201-9, circuit 764 (BR/W), and GEM C241-19, circuit
764 (BR/W).
Page 34 of 64
8/30/2010