1998 Expedition/Navigator Workshop Manual
C32 CHECK THE PID PLATE_B FOR OPEN
C33 CHECK CIRCUIT 770 (W) TO THE CONTACT PLATE SWITCH B
C34 CHECK CIRCUIT 770 (W) FOR SHORT TO GROUND
GEM C241
http://www.fordtechservice.dealerconnection.com/pubs/content/~WSWJ/~MUS~LEN/21/...
762 (Y/W).
Is the resistance less than 5 ohms?
Yes
REPLACE the GEM; REFER to
Section
419-10. CLEAR the DTCs. TEST the system for normal operation.
No
REPAIR circuit 762 (Y/W). CLEAR the DTCs. CYCLE the ignition to OFF, then ON. TEST the system for normal
operation.
NOTE: The active command PLATE PWR is located in the 4-Wheel Electronic Shift active command menu.
Set the active command PLATE PWR to ON.
Monitor the PID PLATE_B.
Does the PID PLATE_B not indicate OPEN?
Yes
GO to C34.
No
GO to C33.
Connect a jumper wire between transfer case assembly C201-10, circuit 762 (Y/W), and C201-1, circuit 770 (W).
Monitor the PID PLATE_B.
Does the PID PLATE_B indicate CLOSED?
Yes
GO to C37.
No
GO to C35.
Measure the resistance between transfer case assembly C201-1, circuit 770 (W), and ground.
Page 49 of 64
8/30/2010