1998 Expedition/Navigator Workshop Manual
A27 CHECK THE A4WD OUTPUT
Transfer Case Assembly C201
A28 CHECK CIRCUIT 779 (BR) FOR OPEN
A4WD Clutch Relay C293
http://www.fordtechservice.dealerconnection.com/pubs/content/~WSWJ/~MUS~LEN/21/...
Is any voltage indicated?
Yes
REPAIR circuit 976 (O). CLEAR the DTCs. TEST the system for normal operation.
No
REPLACE the A4WD clutch relay. CLEAR the DTCs. TEST the system for normal operation.
NOTE: The CLCH SOL active command is located in the Shift Clutch Control active command menu.
Set the active command CLCH SOL to ENERGIZED.
Measure the voltage between transfer case assembly C201-16, circuit 779 (BR), and ground.
Is the voltage less than 5 volts when the active command is set to 0% and greater than 10 volts when
set to 100%?
Yes
REPAIR the transfer case clutch; REFER to
Section
operation.
No
GO to A28.
Measure the resistance between A4WD clutch relay C293-B, circuit 779 (BR), and transfer case assembly C201-
16, circuit 779 (BR).
Is resistance less than 5 ohms?
Yes
GO to A29.
No
REPAIR circuit 779 (BR). CLEAR the DTCs. TEST the system for normal operation.
308-07B. CLEAR the DTCs. TEST the system for normal
Page 16 of 64
8/30/2010