Checking The Blades; Replacing The Blades; Removing The Mulching Plug - Jonsered FR 2213 MA Operator's Manual

4 Set the cutting height control to one of the positions 1-7

Checking the blades

To achieve the best mowing results it is important that the
blades are undamaged and well-sharpened.
Check that the blades' attachment screws are tight.
IMPORTANT INFORMATION
One or more unbalanced blades , caused by damage or
poor balancing after sharpening, can cause vibrations in
the machine.
The blades should be balanced after sharpening.
Damaged blades should be replaced when hitting obstacles
that result in a breakdown. Let the service centre assess
whether the blade can be sharpened or must be replaced.
WARNING! Do not use blades that are
!
cracked, chipped, or otherwise show signs
of damage or severe wear. Replace the
blades. The risk increases if the blades are
poorly balanced.
FR 2213 MA, FR 2216 MA, FR 2216 MA 4X4
• Put the unit in the service position, see Service position
for the cutting unit.
FR 2213 RA
• Lift up the cutting unit
• Set the cutting height control in the highest position.
• Inspect the blades from underneath.
Maintenance

Replacing the blades

• Put the unit in the service position, see Service position
for the cutting unit.
• Lock the blade with a wooden block. Loosen the blade bolt
and remove the blade bolt, the washer and the blade.
Assemble the parts in the reverse order.
• The blade must be mounted with the angled ends pointing
up towards the cover.
• Tightening torque 45-50 Nm (4.5-5 kpm/32-36 lbft).
15mm
!
IMPORTANT INFORMATION
Always exercise care and use your common sense. Avoid
all situations which you consider to be beyond your
capability. If you still feel uncertain about operating
procedures after reading these instructions, you should
consult an expert before continuing. Contact an authorised
service workshop.
Always use genuine parts. For more information, see the
"Technical data" section.

Removing the Mulching plug

FR 2213 MA, FR 2216 MA, FR 2216 MA 4X4
To change a Combi unit from the Mulching function to a
cutting unit with rear ejection, remove the Mulching plug,
which is located under the unit, attached with a knob.
1 Put the unit in the service position, see Service position
for the cutting unit.
2 Loosen the knob and the bolts holding the Mulching plug
and remove the plug.
3 Replace the unit in normal position.
WARNING! Wear gloves to protect your
hands when working with the blades.
– 25
English