Cutting Height Adjustment Lever; Seat; Fueling; Release Lever - Jonsered FR 2213 MA Operator's Manual

Cutting height adjustment lever

The cutting height can be adjusted to 7 different positions with
the cutting height lever.
Combi-unit 30-80 mm

Seat

The seat has a jointed attachment on the front edge and can
be tipped forward.
The seat can also be adjusted lengthways.
Loosen the handles under the seat and adjust it forwards or
backwards to the desired position.

Fueling

The engine runs on unleaded petrol with a minimum octane
rating of 85 (not mixed with oil). We recommend the use of
biodegradable alkylate petrol. Do not use petrol that contains
methanol.
Do not fill the tank completely, leave an expansion area of at
least 2.5 cm (1").
WARNING! Petrol is highly inflammable.
!
Exercise care and refuel outdoors (see
safety instructions).
IMPORTANT! Do not use the fuel tank as a support area.
PRESENTATION
Release lever FR 2213 MA, FR 2216
MA
The release control must be pulled out in order for the
machine to be moved when the engine is shutoff. Pull the
controls to the end positions, do not use an intermediate
position.
• Pull out the control to disengage the drive system.
• Push in the control to engage to the drive system.
Release lever FR 2216MA 4X4
FR 2216 MA 4X4 has one control for the front axle and one
control for the rear axle.
Should you attempt to drive the machine with the clutch
controls pulled out it will not move. The drive on the axle is
disengaged when one of the controls is pulled out.
IMPORTANT! Always drive the machine with both clutch
controls pressed in.
• Clutch control, rear axle
- Control drawn out, drive system disengaged.
- Control depressed, drive system engaged.
• Clutch control, front axle
- Rear control (pulled out), drive system disengaged.
- Front control (pushed in), drive system engaged.
– 13
English