Service Position For The Cutting Unit - Jonsered FR 2213 MA Operator's Manual

Service position for the cutting unit

FR 2213 MA, FR 2216 MA
The cutting head can be placed in the service position to
provide easy access for cleaning, repairs and servicing. In the
service position the cutting unit is raised and locked in the
vertical position.
Placing in the service position
1 Position the machine on flat ground. Apply and lock the
parking brake. Set the cutting height control in the lowest
position and lift up the cutting unit.
1
2
2 Release the clip on the front hood and lift off the fender.
WARNING! Wear protective glasses when
!
dismantling the cutting unit. The spring
which tensions up the belt may break and
cause personal injury.
3 Loosen the spring on the drive belt's belt idler by pulling
the spring eye.
4 Place the spring eye in the holder.
5 Lift off the drive belt and hang on the load-relieving hook.
24 –
English
Maintenance
6 Loosen on the cutting height stay and place in the holder.
7 Grip the front edge of the unit and pull forwards until it
stops.
8 Lift the unit until it stops and a clicking sound is heard.
9 The unit locks automatically in the vertical position.
Restoring from service position
1 Grip the front edge of the unit and loosen the lock, fold
down and slide in the unit.
2 Replace the cutting height stay and the belt. Tension the
belt with the belt adjuster.
3 Fit the front cover.