Adjusting the parking brake
FR 2213 MA, FR 2216 MA
Check that the brake is correctly adjusted by placing the
machine on a slight downhill slope with the clutch disengaged
and activating the brake.
When the machine does not stand still, the brake should be
adjusted according to the following.
1 Loosen the locking nuts (1).
2 Tension the cable using the adjuster screw (2) until the
play in the cable is taken up.
3 Tighten the locking nuts (1).
4 The brake should be checked again after adjustment
WARNING! A poorly adjusted brake can
!
result in reduced braking ability.
Adjusting the parking brake
FR 2216 MA 4X4
Check that the parking brake is adjusted correctly by placing
the machine on a slope with the front and rear axles
disengaged.
Apply and lock the parking brake.
When the machine does not stand still, the brake should be
adjusted according to the following.
•
Remove the left-hand wing cover.
•
Loosen the locking nuts (1).
•
Tension the cable using the adjuster screw (2) until the
play in the cable is taken up.
•
Tighten the locking nuts (1).
•
The parking brake should be checked again after the
adjustment has been made.
•
Assemble the left-hand wing cover.
WARNING! A poorly adjusted parking brake
!
can result in reduced braking ability.
20 –
English
Maintenance
Adjusting the throttle wire
The throttle cable may need to be adjusted, if the engine does
not respond as it should when accelerating, if it produces
black smoke or maximum revs are not reached.
1 Release the clamping screw that secures the wire casing
and set the choke control to maximum choke.
2 Pull the choke wire casing to the far right and tighten the
clamping screw.
3 Pull back the throttle to the full throttle position and check
that the choke is no longer actuated.