Checking The Blades - Jonsered FR2216MA Operator's Manual

WARNING!
!
Wear protective glasses when dismantling
the cutting unit. The spring which tensions
up the belt may break and cause personal
injury.
5 Disengage the spring for the drive belt tensioning wheel.
6 Place a foot on the front edge of the cutting unit near the
wheel and raise the front edge of the unit to make it easier
to remove the lift strut.
1 Engage the strut in the holder.
WARNING! Observe caution to avoid
!
trapping your hand.
2 Lift of the drive belt. Then pull out the pin.
3 Pull the frame forwards and refit the pin.
Maintenance
4 Grasp the front edge of the cutting unit, pull out and raise
into the service position.
If the cylindrical bolt, which is now holding the cutting unit is
removed, the cutting unit can be lifted off.
Restoring from service position
To leave the service position, reverse the procedures set out
in Placing in the service position. Make sure that the cutting
unit's "lug" (3) enters the loop correctly on the underside of the
machine, see diagram.

Checking the blades

To achieve the best mowing results it is important that the
blades are undamaged and well-sharpened.
Check that the blades' attachment screws are tight.
IMPORTANT INFORMATION Replacing or sharpening the
blades should be conducted by an authorised service
workshop.
The blades should be balanced after sharpening.
Damaged blades should be replaced when hitting obstacles
that result in a breakdown. Let the servicing dealer judge
whether the blade can be repaired/ground or must be
discarded.
– 29
English