Checking the blades
To achieve the best mowing results it is important that the
blades are undamaged and well-sharpened.
Check that the blades' attachment screws are tight.
IMPORTANT INFORMATION Replacing or sharpening the
blades should be conducted by an authorised service
workshop.
The blades should be balanced after sharpening.
Damaged blades should be replaced when hitting obstacles
that result in a breakdown. Let the servicing dealer judge
whether the blade can be repaired/ground or must be
discarded.
Removing the Mulching plug
To change a Combi unit from Mulching function to cutting unit
with rear ejection, remove the Mulching plug located under
the unit with three screws.
1 Put the unit in the service position, see Placing in the
service position.
2 Remove the three screws holding the Mulching plug, and
remove the plug.
3 Tip: Fit three full-thread screws M8x15 mm in the screw
holes to protect the threads.
4 Replace the unit in normal position.
Maintenance
Removing the Mulching plug, C94
To change a Combi unit from the Mulching function to a
cutting unit with rear ejection, remove the Mulching plug,
which is located under the unit, attached with a knob.
1 Put the unit in the service position, see Placing in the
service position.
2 Loosen the knob holding the Mulching-plug and remove
the plug.
3 Replace the unit in normal position.
– 27
English