Driving The Rider; Stop The Engine - Jonsered FR 2213 MA Operator's Manual

Driving the Rider

1 Release the parking brake by first pressing down the
parking brake pedal and then releasing it.
2 Carefully press down one of the pedals until the required
speed is obtained. Pedal (1) is used to drive forwards, and
pedal (2) to drive backwards.
3 Select the required cutting height (1-9) with the cutting
height lever.
It is important that the air pressure in both front wheels is
equal, 60 kPa / 0,6 bar / 8.7 PSI, to produce an even
cutting height.
4 Press in the lock button on the lifting lever and lower the
cutting unit.
IMPORTANT INFORMATION
The life span of the drive belts is increased significantly if
the engine runs at a low speed when the blades are
engaged. Therefore apply full throttle first when the cutting
unit has been moved to the mowing position.
16 –
English
Driving

Stop the engine

Always park the machine on a level surface with the engine
OFF.
1 Lift up the cutting unit by pulling the lever backwards to its
locked position.
2 Pull back the throttle and turn the ignition key to the
"STOP" position.
3 When the Rider is at a standstill, press down the parking
brake and push in the locking button.
STOP
START