Service Journal; Pre-Delivery Service; After The First 8 Hours - Jonsered FR 2213 MA Operator's Manual

Pre-delivery service

1 Charge the battery for 4 hours at max. 3 amp.
2 Fit steering wheel, seat and any optional
equipment.
3 Check and adjust tyre pressure. (60 kPa, 0.6 bar,
9 psi).
4 Adjust cutting unit:
Adjust lift springs (effective weight of cutting unit
should be 12-15kg / 26.5-33 lb).
Adjust cutting unit so that rear edge is about 2-4
mm / 1/8" higher than front edge.
Adjust the cutting unit's cutting height setting so
that the connection rod is tensed at the lowest
cutting height.
5 Check that the right amount of oil is in the engine.
6 Check that there is oil in the transmission's oil
tank.
7 Connect battery.
8 Fill with fuel and start engine.
9 Check that machine does not move in neutral.
10 Check:
Forward drive.
Reverse drive.
Operation of blades.
Seat safety switch.
Lif lever safety switch.
Safety switch for the hydrostat pedals/neutral
position.
11 Check engine speed. See the Technical data
section. See the workshop manual.
6 –
English

Service journal

12 Tell customer about:
Needs and benefits of following the service
schedule.
The transmission warranty is only valid if front
and rear wheel rotation speed has be checked in
accordance with the service schedule. Adjust if
necessary according to the table values specified in the
workshop manual. Performed by authorized servicing
dealer. The system will be damaged if this adjustment is
not carried out. (Only 4x4-machines)
Servicing and the influence of this journal on the
second-hand value of the machine.
Range of applications for Mulching.
Complete proof of sale etc.
Pre-delivery service carried out. No outstanding problems.
Certified:
________________________________________________
Date, mileage, stamp, signature
After the first 8 hours
1 Change engine oil
2 Change the oil in the gearbox. (Only 4x4-
machines)
3 Check front and rear wheel rotation speed
according to the service schedule. (Only 4x4-machines)
See the workshop manual.