Service Position For Cutting Unit - Jonsered FRH 13 M Operator's Manual

Service position for cutting unit

The cutting head can be placed in the service
position to provide easy access for cleaning, repairs
and servicing. In the service position the cutting unit
is raised and locked in the vertical position.
Placing in service position
1. Apply the parking brake, see page 8. Adjust the
cutting unit to the lowest cutting height.
2. Disengage the spring from the drive belt
tensioning wheel.
3. Fit the support wheels (1) and lock with the
locking pin (2).
4. Remove the front hood, see page 17, and pull
out the pin.
5. Place a foot on the edge of the cutting unit near
the wheel and raise the front edge of the unit to
make it easier to remove the lift strut. Engage
the strut in the holder.
24
– English
MAINTENANCE
1
2