Service Position For The Cutting Unit - Jonsered FR2218FA2 Operator's Manual

Screw in (shorten) the stay to lower the rear edge of the
cover.
5 Tighten the nuts against each other after adjustment.
6 On completion of the adjustment the unit's parallelism
should be re-checked.
7 Fit the right-hand fender and the front hood.

Service position for the cutting unit

The cutting head can be placed in the service position to
provide easy access for cleaning, repairs and servicing. In the
service position the cutting unit is raised and locked in the
vertical position.
Placing in the service position
1 Position the machine on flat ground. Apply the parking
brake. Set the cutting height control in the lowest position
and lift up the cutting unit.
1
2
2 Remove the front hood by removing the pin.
WARNING! Wear protective glasses when
!
dismantling the cutting unit. The spring
which tensions up the belt may break and
cause personal injury.
3 Disengage the spring for the drive belt tensioning wheel.
24 –
English
Maintenance
4 Loosen on the cutting height stay and place in the holder.
!
5 Remove the drive belt and place it in the belt holder.
6 Grip the front edge of the unit and pull forwards until it
stops.
7 Lift the unit until it stops and a clicking sound is heard. The
unit locks automatically in the vertical position.
WARNING! Observe caution to avoid
trapping your hand.