Connect To The Access Point And Log In; Specify The Access Point Name And Location - NETGEAR WAC120 Reference Manual

Connect to the Access Point and Log In

You can connect to the access point's web management interface to view or change its LAN
and wireless access settings.
To connect to the access point:

1. Configure a computer with a static IP address of 192.168.0.210 and a subnet mask of
255.255.255.0.
For help configuring a static IP address on your computer, check the instructions or online
help that came with that computer.
2. Connect the Ethernet cable to the computer.
3. Connect the other end of the Ethernet cable to the LAN port on the access point.
4. Connect the power adapter to the access point and plug the power adapter into a power
outlet.
5. Press the On/Off button on the access point.
6. On the computer that is connected to the access point, enter http://192.168.0.100 in the
address field of a browser.
A login screen displays.
7. Enter admin for the user name and password for the password.
The web management interface of the access point displays.

Specify the Access Point Name and Location

You must use a computer that is configured with a static IP address of 192.168.0.210 and a
subnet mask of 255.255.255.0. During initial setup, use a wired Ethernet connection from the
computer to the access point.
To specify the access point name and location:

1. Launch a web browser on the computer that is connected to the access point.
2. Enter http://192.168.0.100 in the address field of the browser.
A login prompt displays.
3. Enter the user name and password.
The user name is admin and the default password is password.
802.11ac Wireless Access Point Model WAC120
Initial Setup
13