NETGEAR WAC120 Reference Manual page 45

7. Select the Wireless Point-to-Multi-Point Bridge radio button.
8. To enable wireless client association, select the Enable Wireless Client Association check
box.
9. Select the radio button for the first access point that you want to connect to the base station
and click the Edit button.
10. In the Remote MAC Address field, enter the MAC address of the other access point.
11. Under Authentication Settings, specify the authentication settings for your bridge network.
12. Click the Apply button.
Your settings are saved.
13. Select the radio button for the next access point that you want to connect to the base station
and click the Edit button. Repeat
Step 13
14. Repeat for each of the remaining access points that you want to connect to the
base station.
You can specify up to four access points that connect to the base station access point.
15. For each access point that you want to allow to connect to the base station access point,
select its Enable check box.
16. Click the Apply button.
Your settings are saved.
17. Configure each access point that is to connect to the base station access point in wireless
point-to-point bridge mode.
For more information, see
18. Verify the following parameters for all access points:
802.11ac Wireless Access Point Model WAC120
Step 10
through
Wireless Point-to-Point Bridge Mode
Network Settings
45
Step 12
for this next access point.
on page 41.