Wireless Bridging And Repeating - NETGEAR WAC120 Reference Manual

Decreasing this value increases the priority of the queue. Valid values for maximum
burst length are 0.0 through 999.9.
6. To change the default settings of the station EDCA settings, enter the appropriate
information in the Station EDCA parameters fields.
The following station Enhanced Distributed Channel Access (EDCA) parameters affect
traffic flowing from the client station to the access point:
• AIFS. The Arbitration Inter-Frame Spacing (AIFS) interval specifies, in milliseconds,
the wait time between data frames. Higher AIFS values means higher priority to that
queue. Valid values for AIFS are 1 through 255.
• CwMin. The minimum contention window (CwMin) value specifies the upper limit (in
milliseconds) of a range from which the initial random back-off wait time is
determined. Decreasing this value increases the priority of the queue. The value for
CwMin must be lower than the value for CwMax. Valid values are 1, 3, 7, 15, 31, 63,
127, 255, 511, and 1024.
• CwMax. The maximum contention window (CwMax) value specifies (in milliseconds)
the upper limit for the doubling of the random back-off value. Decreasing this value
increases the priority of the queue. The value for CwMax must be higher than the
value for CwMin. Valid values are 1, 3, 7, 15, 31, 63, 127, 255, 511, and 1024.
• TXOP Limit. The transmission opportunity (TXOP) is an interval of time (in
milliseconds) when a client station can initiate transmissions on the wireless medium
(WM). Decreasing this value increases the priority of the queue. Valid values for
maximum burst length are 0.0 through 999.9.
7. Click the Apply button.
Your settings are saved.

Wireless Bridging and Repeating

You can use the access point as a component to build large bridged wireless networks. The
following modes are available:
802.11ac Wireless Access Point Model WAC120
Network Settings
39