Rear View - NETGEAR WAC120 Reference Manual

Table 1. LEDs (continued)
LED Description
LAN
•
•
•
WiFi
•
•
•
•
The WiFi and WPS buttons toggle the WiFi and WPS functions on and off, as follows:
• WiFi On/Off button. Pressing and holding this button for two seconds turns the 2.4 GHz
and 5 GHz wireless radios on or off. If the WiFi LED is lit, the wireless radios are on. If this
LED is off, the wireless radios are turned off and you cannot connect wirelessly to the
access point.
• WPS button. You can use this button to use WPS to add a wireless device or computer
to your wireless network. The WiFi LED blinks slowly, green for three seconds, then off for
three seconds, when the access point is trying to add the wireless device or computer.

Rear View

The buttons and connections on the back panel are shown in the following figure.
Figure 3. Rear view
Pressing the Reset button restores the factory settings. See
802.11ac Wireless Access Point Model WAC120
Off. No link is detected.
Green. A 1000 Mbps link is detected.
Amber. A 100 Mbps or 10 Mbps link is detected.
Off. Both the 2.4G and 5G radios are off.
Green. The 2.4G, 5G, or both radios are ready.
Blinking green. Wireless activity of 2.4G or 5G is detected.
Slow blinking green. WPS is enabled.
LAN
port
Hardware Setup
Power On/Off
Reset
button
Factory Settings
8
Power connector
on page 66.