NETGEAR WAC120 Reference Manual page 27

To enable WPS, MAC authentication must be in its default state of disabled. For more
MAC Authentication
information, see
To configure WPS:

1. Launch a web browser on the computer that is connected to the access point.
2. Enter http://192.168.0.100 in the address field of the browser.
A login prompt displays.
3. Enter the user name and password.
The user name is admin and the default password is password.
The General screen displays.
4. Select Configuration > WPS.
5. To enable WPS, select the WPS Enable radio button.
WPS is enabled.
6. To disable the access point's PIN, select the Disable AP's PIN check box.
The wireless client cannot use the access point's PIN to connect to the access point.
7. To keep the existing access point's wireless settings when a wireless client uses WPS to
connect to the access point, select the Keep Existing Wireiess Settings check box.
Whether you use the access point's PIN or wireless client's PIN to initiate the connection,
the access point's preconnection wireless settings stay the same. The client's wireless
settings change to the access point's wireless settings after the connection.
8. Click the Apply button.
Your settings are saved.
To connect WiFi devices to your access point with WPS:

1. Launch a web browser on the computer that is connected to the access point.
2. Enter http://192.168.0.100 in the address field of the browser.
802.11ac Wireless Access Point Model WAC120
on page 24.
Initial Setup
27