NETGEAR WAC120 Reference Manual page 16

The General screen displays.
4. Select Configuration > IP.
The IP Settings screen displays.
5. If necessary, specify the following settings:
• DHCP Client. By default, the Dynamic Host Configuration Protocol (DHCP) client is
disabled. If your LAN includes a DHCP server and you enable DHCP, the access
point gets its IP address, subnet mask, and default gateway settings automatically
from the DHCP server on your network when you connect the access point to your
LAN.
• IP Address. The IP address of your access point. The default IP address is
192.168.0.100. To change it, enter an unused IP address from the address range
used on your LAN, or enable DHCP.
• IP Subnet Mask. The access point calculates the subnet mask based on the IP
address that you assign. Otherwise, you can use 255.255.255.0 (the default) as the
subnet mask.
• Default Gateway. The IP address of the gateway for your LAN. For more complex
networks, enter the address of the router for the network segment to which the access
point is connected. The default is 0.0.0.0.
• Primary DNS Server. The IP address for the primary Domain Name Server used by
stations on your LAN. The default is 0.0.0.0.
• Secondary DNS Server.The IP address for the secondary Domain Name Server
used by stations on your LAN. The default is 0.0.0.0.
6. Click the Apply button.
Your settings are saved.
If you changed the subnet of the LAN IP address, you are disconnected from the access
point user interface. To reconnect, reconfigure your computer with a static IP address within
the new LAN IP subnet.
802.11ac Wireless Access Point Model WAC120
Initial Setup
16