Configuring The Internal Siren; Programming The Keypad Sounder; Assigning Codes - GE NX-10 Installer Manual

Data Event
25 Fire
26 Fire trouble
27 Chime
28 Expander trouble
29 Dynamic battery test time
If set to follow condition, these events are one second
Note: When Event 48 is programmed, it is possible to program a user code's authorization to select which output(s)
a particular code activates.

Configuring the internal siren

You can specify conditions and/or events that activate the internal siren. To configure the internal
siren, you must enable the advanced menu. The following example configures a short blast of the
internal siren when the system is armed using a keyswitch.
Ensure the advanced menu is enabled.
1.
Navigate with the
2.
and press OK.
Scroll to Keyswitch Arming>Yes and press OK.
3.
The keypad beeps once to confirm the change and returns to Keyswitch Arming.
4.

Programming the keypad sounder

You can specify conditions and/or events that activate the keypad sounder. To configure the sounder,
you must enable the advanced menu. The following example programs the keypad sounder to
activate when an expander trouble condition occurs.
Ensure the advanced menu is enabled.
1.
Navigate with the
2.
OK.
Scroll to Expander Trouble>Enabled and press OK.
3.
The keypad beeps once to confirm the change and returns to Expander Trouble.
4.

Assigning codes

Figure 15. Installer codes menu
2.3.1 4/6 Digit Codes
Installer Code
2.3.2
Duress Code
2.3.3
Guard Codes 16 17
User Auth for Progrm.
System codes can be either four or six digits long. This menu allows to program/change the installer
code and the duress code. A duress code disarms the system and activates a duress alarm. This is a
Data
55
56
57
58
59
keys to Control Panel>Outputs>Internal Siren>Short Blast On
keys to Control Panel>Outputs>Keypads>Sound On and press
Code
2.3.2.1
Authority
2.3.2.2
2.3.2.3
Partitions
Event
Auxiliary communication failure
Radio test
Any siren when armed in any mode
Alarm memory (pulsating)
Zone inactivity
.
Arm Only After Closing
2.3.2.2.1
2.3.2.2.2 Arm Only
Arm/Disarm
2.3.2.2.3
Master Code
2.3.2.2.4
Bypass Zones
2.3.2.2.5
Reports Open/Close
2.3.2.2.6