GE NX-10 Installer Manual page 210

Term Definition
compatible.
PUK code Personal Unblocking Key. The code to use to unblock the SIM card. The SIM card can block when an
incorrect SIM PIN is entered repeatedly.
R
Receiver Number A Reporting setting that configures the phone line receiver number associated with the receiver
account.
Receiver Polling A Reporting setting that configures the NX-7002 to send polling messages to the report receivers.
Receivers A Reporting menu entry that groups TCP/IP receiver options.
Registered Phone A Reporting menu entry that lists all the users with rights to send HomeText commands from the
Access phone registered in the system.
Note: Only users listed here are granted rights to send HomeText commands to the system.
Removing a user from this list suspends all user's rights to send HomeText commands, including Any
Phone Access privileges.
Relay Unrecognised An Options menu option, that if enabled, sends any unrecognised text messages to the
SMS to Admin administrator.
An Up/download setting that allows an upload/download session between the NX-7002 and the PC
Remote Initiated
to be initiated by the PC. The PC dials into the NX-7002. You must dial the data phone number to dial
into the GSM for upload/download. This setting is dependent on other settings (Allow Calls From,
Auto-answer and Callback Required).
Report Attempts A Reporting menu entry that groups report options.
Report Control A block of reporting data that contains configurations to format selected events into one or more
messages according to pre-configured settings and send them to specified destinations.
A Reporting menu entry that groups report control options.
Report Delay A Reporting setting that configures the delay in seconds before the NX-7002 module reports. If any
other events occur during this delay, they are sent with the first event in one message. This can be
from 0 to 255 seconds. This setting is valid only if using SMS reporting.
A Reporting setting that configures the communicator format used to report to the selected TCP/IP
Report Format
receiver. Consult the instructions for your central station receiver to determine which format is
compatible.
Report Groups A Reporting option that sets which reports are sent to the phone number.
Report Timeout A Reporting setting that configures the maximum length of time for each attempt by the NX-7002 to
report to each receiver. If the report is not successful during this time, the attempt is abandoned. This
can be from 0 to 255 seconds.
Report When A Reporting setting that enables primary reporting (Report Always) or secondary reporting (Panel
Dialer Problem) for the selected report control.
See also Primary Reporting and Secondary Reporting
Report XSIA A Reporting setting that enables XSIA reporting. When this option is enabled, reports are sent in XSIA
format instead of SIA format. In short, it means that User/Zone names will be added to the reports. It
does not affect reports in any other format,.
Reporting A menu entry that groups reporting options for the GPRS module.
An Options menu option that displays a status message when reporting is taking place.
Reset Settings A menu option that defaults the GPRS module. This is a necessary procedure on all components
before starting to program the system.
RF Low Battery and A Reporting setting that sends a report to the selected report control when a low battery condition
Restores occurs in an RF sensor. A restore report is also sent when the low battery condition is no longer
active.