Dual Reporting - GE NX-10 Installer Manual

by default and events for phone numbers 2 - 3 are disabled by default. If phone number 1 and phone
number 2 are programmed, the default sequence is 1,1 2,2 1,1,2,2 for a total of eight calls to each
number.
Table 8. Backup reporting
Level 1 Level 2
Phone Number Phone Number 1
Phone Number 2
Account Code Phone Number 1
Phone Number 2
Protocol Phone Number 1
Phone Number 2
Events Phone Number 1 – Alarms
Phone Number 1 – Alarm Restores
Phone Number 1 – Tampers and Restores
Phone Number 2 – Alarms
Phone Number 2 – Alarm Restores
Phone Number 2 – Tampers and Restores

Dual reporting

Dual reporting configures the control panel to report to two different central stations. Events must be
reported to both phone numbers. The control panel dials the first number twice. If it cannot reach this
number, it dials the second number twice. It performs this sequence for the number of times specified
in Dial Attempts or until it reports the events to both numbers. The same account code is used to
report to both numbers. Events for phone number 1 are enabled by default and events for phone
number 2 are disabled by default.
Table 9. Dual reporting
Level 1 Level 2
Phone Number Phone Number 1
Phone Number 2
Account Code Phone Number 1
Phone Number 2
Protocol Phone Number 1
Phone Number 2
NX-10 Installers manual
Value State
123456
456789
BE5566
445566
SIA
SIA
Enabled
Enabled
Enabled
Disabled
Disabled
Disabled
Value State
123456
456789
BE5566
445566
SIA
SIA
45