GE NX-10 Installer Manual page 207

Term Definition
Downloading An Options setting option that indicates that downloading is taking place.
E
Event An alarm condition that has been detected by the control panel.
Event log A list of events that occur in the system regardless of the armed state of the system. They are held in
a sequential event buffer with a time and date stamp. When the log is full, it overwrites the oldest
entries with new data. These events can later be viewed through downloading.
Events A Reporting menu entry that contains all configurable events for each report control. All events for
report control 1 are enabled by default. Events for all other report controls are disabled by default.
Enabled events are formatted into one or more messages according to pre-configured settings and
sent to the selected report destination.
You must enable Test Reports if using the NX-7002 as backup to another auxiliary dialer.
Expander Trouble A Reporting setting that sends an expander trouble and restore report to the selected report control.
and Restores
F
Fail to Communicate A Reporting setting that reports a fail to communicate event to the selected report control.
FTC Report Attempts A Reporting setting that configures the number of attempts that can be made to a specific report
destination before the Fail to Communicate condition is set. This can be from 1 to 15.
G
Good RSSI An Options setting that indicates that the current RSSI level is equal to or greater than the minimum
signal quality level configured in Line Fault RF Level. If the RSSI level drops below this value a GSM line
fault is indicated.
GPRS General Packet Radio Service. A global standard for wireless communications. It supports a range of
bandwidths and can transmit and receive both small bursts and large amounts of data.
An Options menu entry that allows a GPRS connection for up/download.
An Options setting that configures the GPRS access point name. Contact the network provider to
GPRS APN
obtain this name. This is a mandatory setting if using TCP/IP reporting.
GPRS APN 2 An Options setting that configures a second GPRS access point name. Contact the network provider
to obtain this name. This is used if the connection cannot be made via the GPRS APN.
GPRS Connected An Options setting that indicates that the module is logged into the GPRS network.
GPRS Disconnect This contains the length of time with no activity before the GPRS disconnects.
Delay
GSM Global System for Mobile Communications. A global standard for wireless communications. It
supports narrowband Time Division Multiple Access (TDMA).
An Options menu entry that groups GSM connection options.
GSM Connection An Options menu entry that groups GSM connection settings.
GSM Engine Comms An Options setting that indicates that communication with the GSM module is established.
GSM Engine Info An Options menu entry that groups information returned from the on-board GSM module on the GSM
module.
GSM Operator An Options menu entry that groups information on the current GSM operator and allows a specific
GSM operator to be manually selected.
H
An Options setting that indicates that the maximum number of reports allowed in 24 hours has been
Hit 24H Report Limit
reached. This applies to SMS and GPRS reports.
NX-10 Installers manual
207