GE NX-10 Installer Manual page 128

LOCATION 169 - CONFIGURATION GROUP 30 CHARACTERISTIC SELECT (5 segments, feature
selection data)
Use the "Configuration Group Characteristic Selections" described in Location 111.
LOCATIONS 170-205 - RESERVED
LOCATION 206 – AUTO DISARM DAY SELECTOR (4 segments, feature selection data)
Location 206 selects which days each partition will auto disarm. Segment 1 is for partition 1 and
segment 4 is for partition 4.
Segment 1-4 1 =
2 =
3 =
4 =
5 =
6 =
7 =
8 =
LOCATIONS 207-211 - RESERVED
LOCATION 212 – PROGRAMMING THE LCD KEYPAD ADDRESS (1 segment, numerical data)
The system requires at least 1 LCD keypad. The panel will get the zone descriptions from the first
language from that LCD keypad which has the address defined in location 212. It is recommended
that it will be placed in location 1 keypad 1. This will allow location 212 to be left at the factory
default. If the LCD keypad is selected as something other than partition 1 / keypad 1, program the
appropriate address in location 212. Select the address from the location chart.
Keypad Part 1
1 192
2 200
3 208
4 216
LOCATION 213 – PROGRAMMING THE COUNTRY CODE (1 segment, numerical data)
The NetworX system has the ability to set different "country codes". Each country code has specific
default settings. Before start programming the system, it is important to select the country code that
is required (see table below). Once the country code has been selected, it will remain set, even after
an installer reset. When changing the country code during programming, all existing programming
will be cleared to the defaults for that country.
Code
0 No country (factory setting)
1
2
3
4
Auto disarming on Sunday
Auto disarming on Monday
Auto disarming on Tuesday
Auto disarming on Wednesday
Auto disarming on Thursday
Auto disarming on Friday
Auto disarming on Saturday
Reserved
Part 2 Part 3 Part 4
193 194 195
201 202 203
209 210 211
217 218 219
Country
Holland
Belgium / Poland
Sweden
Italy