Section 11-Options; Installing/Cleaning Telescoping I.v. Rod/O2 Holders; Installing - Invacare 9000 SL Owner's Operator And Maintenance Manual

SECTION 11—OPTIONS
SECTION 11—OPTIONS
After any adjustments, repair or service and before use, make sure all attaching
hardware is tightened securely. Otherwise injury or damage may occur.
NOTE: The options in this section refer to non-recliner models only. Refer to Recliner on page 59
for 9000XT Recliner options.
Installing/Cleaning Telescoping I.V. Rod/O
NOTE: For this procedure, refer to FIGURE 11.1.

Installing

WARNING
The telescoping I.V. rod/O
be checked weekly to ensure it is tightly
secured to the wheelchair frame. If
there is any looseness whatsoever,
tighten the attachment hardware
securely before using.
TELESCOPING I.V. ROD HOLDER
ONLY - Make sure the telescoping I.V.
rod is tightly locked before placing I.V.
medication on the rod.
The telescoping I.V. rod is designed to
support I.V. medication only. DO NOT
use it to support objects other than I.V.
medication.
1. Slide telescoping I.V. rod/O
over the step tube of the wheelchair.
NOTE: Mounting bracket of telescoping I.V.
rod/O holder should be positioned between the
2
two axle mounting positions on wheelchair
frame.
2. Secure telescoping I.V. rod/O
the wheelchair frame with hex screw,
spacer and locknut.
9000 Series
WARNING
holder must
2
Telescoping I.V.
holder
2
holder to
2
70
2
DETAIL "A" - I.V. ROD/O 2 HOLDER
Mounting
Bracket
Rod Holder
Locknut
Axle Mounting Positions
Step Tube
DETAIL "B" - O 2 HOLDER
Mounting
Bracket
Locknut
Axle Mounting Positions
Step Tube
FIGURE 11.1 Installing/Cleaning
Telescoping I.V. Rod/O2 Holders
Holders
Tie Wrap
Hex
Screw
Spacer
Hex
Screw
Spacer
Part No.1056953