Invacare 9000 SL Owner's Operator And Maintenance Manual page 43

4. Reposition the arm socket to one of two positions:
CONVENTIONAL SPACE SAVER
NOTE: Make sure arm sockets sit flush against the wheelchair frame.
5. Reinstall the hex screw and locknut that secure the arm socket to the wheelchair frame
and securely tighten.
6. Repeat STEP 5 for the opposite side of the wheelchair.
7. Install the new arms onto the wheelchair. Refer to Removing or Replacing Armrest on
page 41.
8. Refer to the following chart to determine if the rear wheel axle spacer is needed:
CONVENTIONAL
SPACE SAVER
9. If rear wheel axle spacer is needed, refer to Removing/Installing Rear Wheels on
page 47.
Space Saver Arm Position
Arm Socket (Inside of
Wheelchair Frame)
Locknut
Left Side of
Wheelchair Frame
FIGURE 5.5 Converting Between Space Saver and Conventional Arms
Part No.1056953
ARM TYPE
ARM TYPE
Hex Screw
Wheelchair
Frame
ARM SOCKET POSITION (ON
WHEELCHAIR FRAME)
Outside
Inside
AXLE SPACER NEEDED?
Yes
No
Conventional Arm Position
Arm Socket (Outside of
Wheelchair Frame)
Locknut
Right Side of
Wheelchair Frame
43
SECTION 5—ARMS
Hex Screw
9000 Series