Replacing Headrest/Back Upholstery; Headrest Upholstery; Back Upholstery; Adjusting Headrest/Back Upholstery Tension - Invacare 9000 SL Owner's Operator And Maintenance Manual

Replacing Headrest/Back Upholstery

NOTE: For this procedure, refer to FIGURE 10.3.

Headrest Upholstery

1. Remove the headrest pillow. Refer to
Replacing Headrest Pillow on page 60.
2. Remove the six mounting screws that
secure the headrest upholstery to the
headrest extension tubes.
3. Secure new headrest upholstery onto
headrest extension tubes with the
existing six mounting screws.
4. Install headrest pillow. Refer to
Replacing Headrest Pillow on page 60.

Back Upholstery

1. Remove one knob from one side of the
spreader bar.
2. Loosen, but do not remove the
remaining knob.
NOTE: To remove and install the bottom two
mounting screws of the back upholstery, the
wheelchair must be partially folded.
3. Remove the twelve mounting screws
that secure the back upholstery to the
back canes.
4. Secure the new back upholstery to the back canes with the existing twelve mounting
screws. Securely tighten.
5. Install the knob removed in STEP 1 to secure spreader bar to side frame. Securely
tighten both knobs.

Adjusting Headrest/Back Upholstery Tension

NOTE: For this procedure, refer to FIGURE 10.4.
1. Rotate the spreader bar in one of the following directions:
• Counterclockwise (away from back upholstery) to loosen back/headrest
upholstery.
• Clockwise (towards back upholstery) to tighten back/headrest upholstery.
Part No.1056953
Headrest
Extension
Tube
Knob
Back
Cane
FIGURE 10.3 Replacing Headrest/Back
Upholstery
61
SECTION 10—RECLINER
Headrest
Upholstery
Mounting
Screws
Back
Upholstery
Mounting
Screws
9000 Series