Removing Or Replacing Armrest; Removing Armrests - Invacare 9000 SL Owner's Operator And Maintenance Manual

2. Pull the front of the swing-back arm
straight up/out of the arm socket and
towards the rear of the wheelchair.
3. To use the swing-back arm, push the
swing-back arm towards the front of
the wheelchair and then downward
into the arm socket.
NOTE: Armrest release lever MUST be in the
unlocked position when placing armrest into
the arm sockets.
4. Lock the swing-back arms by rotating
the armrest release lever towards the
inside of the wheelchair.

Removing or Replacing Armrest

Make sure the armrest release lever is in the locked position before using the
wheelchair.
9000XDT: Use only heavy duty, fixed height armrests on 9000XDT wheelchairs.
Otherwise injury or damage may occur.
Heavy duty, fixed height armrests are identified by a circular mark on the rear arm
post above or below the armrest release handle.
NOTE: For this procedure, refer to FIGURE 5.3.
NOTE: This procedure does not apply to 9000 SL wheelchairs equipped with space saver arms.

Removing Armrests

1. Unlock the armrest by turning the armrest release levers towards the outside of the
wheelchair.
2. Lift armrest completely out of arm sockets from the wheelchair.
NOTE: Identifying circular mark located on the rear arm post above or below the release lever.
Part No.1056953
WARNING
Rear Arm Post
Armrest
Release Lever
Arm Socket
FIGURE 5.3 Removing or Replacing Armrest
Swing Back
Arm
Rear
FIGURE 5.2 Using Swing-Back Arms
Armrest
Arm Socket
41
SECTION 5—ARMS
Front
Armrest
Release
Lever
Arm Socket
Armrest
Release Lever
9000 Series