Installing Anti-Tippers; Removing/Installing Rear Wheels - Invacare 9000 SL Owner's Operator And Maintenance Manual

SECTION 10—RECLINER

Installing Anti-Tippers

NOTE: For this procedure, refer to
FIGURE 10.7.
1. Install the anti-rattles onto the rear
frame tubes if not already in place
(Detail "A").
2. Position the anti-tippers with the
anti-tipper wheels pointing toward the
ground/floor
3. Press the release buttons.
4. Insert the anti-tippers into the rear
frame tubing until the bottom release
button locks in place.
NOTE: Refer to Detail "B" of FIGURE 10.7
and the following chart to ensure the correct
anti-tipper is installed in the wheelchair.
Seat-to-floor heights are approximate
depending on front caster type. The anti-tipper
height measurement MUST be taken with the
anti-tipper on a flat surface.
WHEEL SIZE SEAT-TO-FLOOR
REAR/CASTER
24/8-inch 19½-inches
22/8-inch 18½-inches
20/8-inch 17½-inches

Removing/Installing Rear Wheels

Changing the size of the rear wheel or the seat-to-floor height MUST be performed
only by a qualified technician.
NOTE: Use this procedure to replace a rear wheel with one of the same size.
9000 Series
9000 XT RECLINER
ANTI-TIPPER
HEIGHT LENGTH/HEIGHT
11½ / 2½-inches
10¼ / 1-7/8-inches
10 / 1½-inches
WARNING
DETAIL "A"
Anti-Tipper
Wheels
Anti-Tipper
Anti-Tipper
Height
FIGURE 10.7 Installing Anti-Tippers
ON CHAIR
1021767
1061110
1061109
64
Release
Buttons
Rear Frame
Tubing
Anti-Rattle
DETAIL "B"
Anti-Tipper
Length
OFF CHAIR
KIT NUMBER
1021767
1061110
1061109
Part No.1056953