Section 5-Arms; Adjusting Armrest Height; Using Swing-Back Arms - Invacare 9000 SL Owner's Operator And Maintenance Manual

SECTION 5—ARMS
SECTION 5—ARMS
After any adjustments, repair or service and before use, make sure all attaching
hardware is tightened securely. Otherwise injury or damage may occur.

Adjusting Armrest Height

Make sure the height adjustment lever is in the locked position before using the
wheelchair.
NOTE: For this procedure, refer to FIGURE 5.1.
1. Unlock the armrest by flipping the
height adjustment lever on the top
front of the armrest to the up
(horizontal) position.
2. Adjust armrest to one of five positions.
NOTE: Height adjustment lever MUST be in
the unlocked position when placing armrest
into the arm assembly.
3. Lock the armrest by pressing the height
adjustment lever into the down
(vertical) position when the desired
armrest height is achieved.
4. Repeat STEPS 1-3 for other armrest.

Using Swing-Back Arms

Make sure the armrest release lever is in the locked position before using the wheel-
chair.
NOTE: For this procedure, refer to FIGURE 5.2.
NOTE: This procedure applies to 9000SL, 9000XT, and 9000XDT wheelchairs only.
1. Unlock the swing-back arms by rotating the armrest release lever toward the outside
of the wheelchair.
9000 Series
WARNING
WARNING
Locked (Vertical)
Unlocked (Horizontal)
FIGURE 5.1 Adjusting Armrest Height
WARNING
40
Height
Adjustment
Armrest
Lever
Part No.1056953