Section 6-Seat And Back; Replacing Seat Upholstery; Replacing Back Upholstery; Screw-On Back Upholstery - Invacare 9000 SL Owner's Operator And Maintenance Manual

SECTION 6—SEAT AND BACK
SECTION 6—SEAT AND BACK
After any adjustments, repair or service and before use, make sure all attaching
hardware is tightened securely. Otherwise injury or damage may occur.
NOTE: The procedures in this section apply to non-recliner models only. For 9000XT recliner
models, refer to Recliner on page 59.

Replacing Seat Upholstery

NOTE: For this procedure, refer to FIGURE 6.1.
1. Remove the mounting screws that secure the existing seat upholstery to the
wheelchair frame.
NOTE: The following chart determines the number of mounting screws for each seat depth.
2. Remove the existing seat upholstery from the wheelchair frame.
3. Install new seat upholstery by reversing STEPS 1-2.

Replacing Back Upholstery

Screw-On Back Upholstery

NOTE: For this procedure, refer to FIGURE 6.2.
NOTE: This procedure applies to 9000 SL without adjustable back angle option.
9000 Series
WARNING
SEAT DEPTH
16-INCH
17-INCH TO 20-INCH
Mounting Screws
FIGURE 6.1 Replacing Seat Upholstery
NUMBER OF
SCREWS
8
10
16-inch Seat Depth
Wheelchair Frame
44
Seat Upholstery
Part No.1056953