Phase 6: Pulley Cover Assembly And Belt Installation; Belt Installation - Central Machinery 67595 Set Up And Operating Instructions Manual

phaSe 6: pulley cover assembly
and Belt installation
F l
required hardware
letter description
F M6 x 12 Bolt
G M5 x 15 Pan Head Bolt
L M6 Washer
M M5 Washer
N M5 Nut
P Pulley Cover Knob
Figure For Step 6-1
1. Set the Pulley Cover (17A) over the Pul-
ley (86B) as shown above, with the door
opening to the outside. Insert a Pan
Head Bolt (G) through a Washer (M) and
into each of the four holes. Secure the
Bolts from underneath using one Washer
(M) and Nut (N) each.
2. Secure the Pulley Cover Knob (P) to the
door using Bolt (F) and Washer (L) from
the other side. do not overtighten.
3. Close the Pulley Cover door temporarily
to make sure it closes completely and
securely.
SKU 67595
g
p
qty
(for this phase)
17a
For technical questions, please call 1-800-444-3353.

Belt installation

4. Slide the Motor up towards the top of its
rail to allow easy belt installation.
M
Figure For Step 6-6
pulley Speed Settings
n
position
output
FpM
note: The unnumbered inner-
1
most position on the Middle
4
1
Pulley (1D) should ONLY
8
be used to drive the Belt Pul-
4
ley (86B, not shown), and
1
should not be used to change
speeds.
5. Using the chart above, choose which
speed you would like the blade to oper-
ate at initially. Slide the V-Belt (5D) onto
the desired Motor Pulley (3D) position.
Then slide the Belt up over the Middle
Pulley (1D) in the same position.
6. To set the V-Belt (5D) tension, have an
assistant pull down on the Motor (11A)
and hold it in place to put tension on the
Belt. Then test the belt's tension by gen-
tly pushing in on it in between pulleys.
If it only deflects about 1/2" to 3/4" from
straight, then the belt is properly ten-
sioned at that motor position. While the
assistant holds the motor at that position,
secure the motor in place with the previ-
ously loosened Bolts (D) and Nuts (K).
7. After tightening, verify that both pulleys
are still aligned.
1 2 3
600 1140 1670 2670
1
2
3
4
4
1d
3d
1
2
3
4
REV 10k
Page 16