B - Remove The Shipping Bolt; C - Attach The Pulley Cover - Central Machinery 93507 Assembly And Operating Instructions Manual

(END VIEW)
WhEEL ShAFT
WhEEL (35)
(34)
FIGURE E
1. Turn the lever on the Hydraulic Cylinder (20) to the "OFF" (horizontal) position.
2. Remove Hex Head Screw (170) that holds the Bracket (172) to the Saw Arm. Save
this Screw for any future transport.
Check that the Saw arm prevents the Toggle Switch (37) from entering its "ON" posi-
3.
tion. If it does not, adjust the Stop Screw (60) to lower the Saw Arm until it does.
4. Make certain that the blade cannot contact the table with the Saw Arm lowered
completely. If it can, adjust the Stop Screw (60) to raise the Saw Arm.
Slide the two openings in the Pulley Cover (189) under the two Pulleys (184, 185).
Secure the Pulley Cover, using one Screw (187) and one Washer (188). Then close
the lid of the Pulley Cover, and secure the lid with the Thumb Screw (190).
(See Figure F.)
For technical questions, please call 1-800-444-3353.
SKU 93507
WAShER
(33)
COTTER PIN
(36)
LEFT LEG
(2)
WhEEL (34)

B - Remove The Shipping Bolt

C - Attach The Pulley Cover

PULLEY COVER (189)
SCREW (187)
WAShER (188)
WhEEL (34)
ThUMB SCREW
(190)
FIGURE F
RIGhT LEG
(3)
REV 10/06
Page 12