Assembly; Phase 1: Stand Assembly - Central Machinery 67595 Set Up And Operating Instructions Manual

aSSeMBlY

phaSe 1: Stand assembly

e
required hardware
letter description
E M8 x 16 Carriage Bolt
H M8 Washer
K M8 Nut
3a
7a 10a
Stand Part Identification
part description
1A Mounting Plate
2A Rear Panel
3A Front Panel Assembly
7A Horizontal Brace
8A Brace
9A Motor Plate Bracket
10A Motor Plate
note: During this phase, finger tighten all
Nuts to allow adjustment and leveling.
All connections in this phase are made
with one Carriage Bolt (E) going through
the connection from the outside then be-
ing secured with a Washer (H) and Nut
(K).
SKU 67595
h k
qty
(for this phase)
24
24
24
2a
1a
9a
For technical questions, please call 1-800-444-3353.
Figure For Step 1-1
1. Assemble the Mounting Plate (1A) to the
four square holes at the top of the Front
Panel (3A) assembly as shown above.
The Mounting Plate must be turned as
shown above, with the Belt Cutout hole
away from the Front Panel.
Figure For Step 1-2
8a
qty
1
1
1
2
1
1
1
2. Assemble the Rear Panel (2A) to the
Mounting Plate (1A) in the same way.
The Stand should look like the illustration
above (Figure 1-2).
Belt
Cutout
1a
3a
1a
2a
3a
Page 9