Phase 2: Bandsaw Body To Stand Assembly - Central Machinery 67595 Set Up And Operating Instructions Manual

Figure For Step 1-7
9a
7. Attach the Motor Plate (10A) to the Motor
Plate Bracket (9A). Connect the end that
is folded back on itself.
Figure For Step 1-8
7a
8. Attach the other end of the Motor Plate
(10A) to the Horizontal Brace (7A).
9. Make sure the stand rests square on the
floor and that the Mounting Plate (1A)
is level. Then, wrench tighten all Nuts
from phase 1 securely.
SKU 67595
10a
10a
For technical questions, please call 1-800-444-3353.
phaSe 2: Bandsaw Body to Stand
assembly
B
required hardware
letter description
B M8 x 40 Bolt
H M8 Washer
J M8 Lock Washer
K M8 Nut
Figure For Step 2-1
Stand
Mounting
SlotS
1. Orient the Saw Body with the Stand be-
fore lifting it. The Pulley(s) need to align
over the belt cutout and the four bolt
holes must line up with the stand mount-
ing slots, as shown above.
h j
qty
(for this phase)
4
8
4
4
top View
part 1a
Belt
cutout
Page 11
k