Phase 4: Motor Wiring - Central Machinery 67595 Set Up And Operating Instructions Manual

phaSe 4: Motor Wiring

and death:
unplug power cord before
opening Switch cover (13a).
Figure For Step 4-1
1. After the power cord is unplugged, re-
move the Bolts (28A) from above and
below the Switch (12A) to release the
Switch Cover (13A). Inside the stand,
move the Switch Cover slightly to the
side to allow access.
2. Insert the motor cord through the hole in
the side of the Switch Cover (13A).
Figure For Step 4-3
poWer
cord
Black (hot)
Motor terMinal
3. The power cord wires are already con-
nected at the top connections (black
"hot" wire, white "neutral" wire, and green
SKU 67595
to preVent
electric Shock
reMoVe
theSe
BoltS.
White (neutral)
Motor terMinal
green
(ground)
Motor
terMinal
Motor
cord
For technical questions, please call 1-800-444-3353.
ground wire). Connect the wires from
the motor underneath the wires of the
same color, black with black, white with
white, and green with green. (The green
wire is attached to the screw to the right
of the Switch (12A).)
4. Warning! to preVent
electric Shock, Fire
and death:
it is critical that the green
ground wire is attached to
the terminal outSide the
switch box and that onlY
the green wire is attached
outside the switch box. the
included terminals are designed to
reduce the risk of improper wiring;
do not ModiFY, replace or
Force the terMinalS.
if you have any doubt about your abil-
ity to connect the motor wires safely
and securely, have a certified electri-
cian connect the wiring.
5. After the wiring is properly connected,
carefully hold the Switch Cover (13A) in
place and secure in place with the Bolts
(28A).
Page 14