Pulley Mounting - Central Machinery 60564 Owner's Manual & Safety Instructions

Bandsaw Body to
Stand Assembly
1. Orient the Saw Body with the Stand before lifting it.
The Pulley(s) need to align over the belt
cutout and the four bolt holes must line
up with the stand mounting slots.
2. With at least one assistant, lower the Bandsaw
Body down on the Stand's Face Plate.
Make sure that the holes in the Body line up with
the slots in the stand and that the pulley lines
up over the belt cutout. See Figure 8, right.
3. Insert the four Bolts (91A) through one
Washer (93A) each and into the holes
in the Saw Body from the top.
4. Attach each Bolt using Washer, Lock Washer (92A),
and Nut (48A). Leave the hardware only finger tight.
5. Measure to verify that the saw body is properly
aligned to the stand. Make needed adjustments,
then wrench tighten the hardware.
Motor to Stand Assembly

- pulley Mounting

1. Remove the tape securing the Key (10-1) to the
shaft of the Motor (10). Set the Key aside.
2. The Key for this saw's Motor shaft will need
to be offset by about 0.3" from the end of the
shaft to allow the Set Screw (13) to function
properly. To assist in this, thread a M5 Nut (60)
all the way onto a M5 x 15 Pan Head Bolt (53)
for temporary use as a depth gauge.
3. Slide the Motor Pulley (12) over the end of the
Motor's shaft, larger end first. Line up the Key
slots in both the Pulley and the Motor Shaft.
Slide the Key (10-1) into the slots. Align the end
of the Pulley, Key, and Shaft with one another.
See Figure 9, right. The Motor Pulley will
need to be held in this position for now.
4. Hold the Motor Pulley in place and insert the depth
gauge you made in step 2 into the Key slot, pushing
the key into position. The depth gauge can now be
disassembled and placed with the other hardware.
5. While holding the Motor Pulley in place, tighten
the Set Screw (13) in the side of the Pulley to
secure it to the shaft. See Figure 10, right.
The Pulley will no longer need to be held in place.
Page 8 For technical questions, please call 1-800-444-3353.
91A
Figure 8
Belt Cutout
Face
Plate (1)
58
53
Key (10-1)
Figure 9
Figure 10
93A 92A 48A
Saw
Pulley
(103A)
Saw
Body
57 60
Motor
Pulley
(12)
Motor
Shaft
Motor
(10)
Set
Screw
(13)
Motor
Pulley
(12)
Item 60564