Central Machinery 67595 Set Up And Operating Instructions Manual page 10

Figure For Step 1-3
2a
7a
3. Attach the two Horizontal Braces (7A)
inside the flanges on the Front and Rear
Panels (3A, 2A).
Figure For Step 1-4
4. Attach the Motor Plate Bracket (9A)
to the front of the Mounting Plate (1A)
with the raised section of it towards the
center. The Motor Plate Bracket (9A)
should be near the Switch Cover (13A)
as shown above.
Attach the Brace (8A) under the Mount-
ing Plate (1A) toward the rear as shown
above (Figure 1-4).
SKU 67595
7a
3a
8a
1a
9a
For technical questions, please call 1-800-444-3353.
h
letter
H M8 Washer
K M8 Nut
O Foot Assembly
Q Foot Bracket
Figure For Step 1-5
q
theSe holeS
MuSt line up.
5. Press a Foot Bracket (Q) over each
corner of the Front and Rear Panels (3A,
2A). One of the holes in the Bracket
13a
should line up with the hole in the corner
of the Panel as shown.
Figure For Step 1-6
6. Insert a Foot Assembly (O) through each
Foot Bracket (Q) and Panel (3A, 2A).
Secure with Washer (H) and Nut (K).
k o
required hardware
description
3a
q
o
3a
q
qty
(for this phase)
4
4
4
4
Page 10