Central Machinery 67595 Set Up And Operating Instructions Manual page 22

22. Loosen the two Knobs (131B) under the
Table (122B) and pivot the Table forward
as far as possible.
Figure For Step 8-23
112B
119B
23. Loosen the two Hex Head Bolts (119B)
on the side of the Lower Support Bracket
(112B) and adjust the Lower Blade
Guides' (117B) positions so that they line
up with the flat portion of the Saw Blade
(56B) without reaching the cutting edge;
see Guide and Blade Alignment diagram
above step 18. Tighten the Bolts (119B)
after adjustment.
24. Pivot the Table (122B) backward as far
as possible.
SKU 67595 For technical questions, please call 1-800-444-3353.
Figure For StepS 8-25 to 8-26
Blade guide
adjuStMent
thuMB BoltS
(118B)
25. Loosen the two blade guide adjustment
Thumb Bolts (118B) and move the Lower
Blade Guides (117B) as close as pos-
sible to the side of the Saw Blade without
touching it. Then, tighten the Thumb
Bolts.
26. Loosen the bearing adjustment Thumb
Bolt (116B) and adjust the Bearing
(114B) to 1/64" (0.4mm) behind the Saw
Blade. Then, tighten the Thumb Bolt.
27. Return the Table (122B) to its normal po-
sition and secure with the Knobs (131B)
Bearing
adjuStMent
thuMB Bolt
(116B)
Page 22