Table of Contents
Advertisement
Replacement HDDs are not shipped with any system software pre-installed. After install-
ing the drive, you need to install the appropriate system software.
b. TO REPLACE THE HDD
1. If you are installing a new HDD, unpack the drive.
Do not drop, jar, or bump the HDD. Do not touch the HDD with magnetic objects or
place objects sensitive to magnets near the HDD.
2. Position the HDD inside the chassis and align the mounting holes with the four holes in
the chassis.
The HDD should be positioned as shown in F04-406-02 on page 4-46.
3. Once the HDD is properly aligned in the chassis, replace the screws on each side of the
HDD and tighten them. (Make sure you use the same screws you removed earlier.)
4. Connect the HDD ribbon cable to the HDD.
Make sure to connect the longer end (with the blue connector) of the HDD
ribbon cable to the HDD. Also, make sure not to switch the CD-ROM and
HDD ribbon cables. The CD-ROM ribbon cable has 40 wires; the HDD rib-
bon cable has 80 wires.
5. Connect the 4-pin power supply cable to the HDD.
The connectors are keyed to fit only one way.
6. Replace the front panel (see page 4-8).
7. Reassemble the iR-M2 (see page 4-13).
8. Connect the cables you removed from the back panel.
9. If you replaced the HDD with a new HDD, install system software (see page 4-56).
If a startup error appears on the Control Panel when you power on the iR-M2, check the
connections.
10. Verify iR-M2 functionality (see the connection verification steps described on page 4-
15).
COPYRIGHT © 2002 CANON INC.
2000 2000 2000 2000
NM-PDL REV.0 JULY 2002
CHAPTER 4 SERVICE PROCEDURE
4-47
Advertisement
Table of Contents
